Plastics firm fined after Liverpool worker loses four fingers
January 13, 2010
A plastics-recycling company in Liverpool has been fined £2,500 after a worker had four fingers cut off by a guillotine.
The Health and Safety Executive prosecuted Centriforce Products Ltd following the incident at the companys premises on Derby Road near the citys docks on 26 May 2008.
The court heard that Wesley Dickinson, 22 from Walton, had been trying to remove a jam in the guillotine when his fingers became trapped. Doctors were able to reattach two of his four fingers and he now has very limited movement in his right hand.
Centriforce pleaded guilty to breaching Regulation 11(1) of the Provision and Use of Work Equipment Regulations 1998 at Liverpool Magistrates Court on Friday 8 January 2010. The company was ordered to pay £2,438 towards the cost of the prosecution in addition to the fine.
HSE Inspector Martin Paren said:
"This incident has had a devastating impact on Mr Dickinson, who is only in his early 20s. He cannot return to his old job and will not be able to do manual work in the foreseeable future, due to the limited strength and movement in his right hand.
"The company should have had a guard on the guillotine to prevent workers from reaching the blade. An automatic mechanism should also have been in place so that the power was cut if the guard was opened.
"Instead Mr Dickinson wrongly assumed that a colleague had switched the guillotine off, and he had four fingers cut off as a result.
"This extremely serious incident demonstrates how important it is for manufacturing companies to have automatic safety systems, so that the risk of workers being injured is significantly reduced."
There were nearly 26,000 injuries in the UK manufacturing sector in 2007/8, including 35 deaths.
Find out more about Risk Assessment
The Health and Safety Executive prosecuted Centriforce Products Ltd following the incident at the companys premises on Derby Road near the citys docks on 26 May 2008.
The court heard that Wesley Dickinson, 22 from Walton, had been trying to remove a jam in the guillotine when his fingers became trapped. Doctors were able to reattach two of his four fingers and he now has very limited movement in his right hand.
Centriforce pleaded guilty to breaching Regulation 11(1) of the Provision and Use of Work Equipment Regulations 1998 at Liverpool Magistrates Court on Friday 8 January 2010. The company was ordered to pay £2,438 towards the cost of the prosecution in addition to the fine.
HSE Inspector Martin Paren said:
"This incident has had a devastating impact on Mr Dickinson, who is only in his early 20s. He cannot return to his old job and will not be able to do manual work in the foreseeable future, due to the limited strength and movement in his right hand.
"The company should have had a guard on the guillotine to prevent workers from reaching the blade. An automatic mechanism should also have been in place so that the power was cut if the guard was opened.
"Instead Mr Dickinson wrongly assumed that a colleague had switched the guillotine off, and he had four fingers cut off as a result.
"This extremely serious incident demonstrates how important it is for manufacturing companies to have automatic safety systems, so that the risk of workers being injured is significantly reduced."
There were nearly 26,000 injuries in the UK manufacturing sector in 2007/8, including 35 deaths.
Find out more about Risk Assessment
More Court Cases news:
Worker left paralysed after being crushed by 600 pound steel beam - August 31, 2010Falling panel saw leaves employee brain damaged - August 26, 2010
GBP15,000 fine after worker left with hole through his shin - August 25, 2010
Lack of risk assessment leads to car falling from pier - August 25, 2010
GBP8,000 fine for steeplejack firm - August 17, 2010
